Robnor New Product Launch PX19-GE3259-03 Epoxy Foam

We are pleased to announce the launch of a brand-new development material, PX19-GE3259-03.

The epoxy foam offers good adhesion to a wide variety of substrates.

Where can PX19-GE3259-03 be used?

The two-component epoxy system is particularly suitable for void-filling applications and has good compressive strength for backfilling of parts. It can also be used in the casting of buoyant materials, or as a machinable epoxy foam for model making.

What makes this epoxy foam special?

The lightweight foam has a low density of approximately 0.3g/cm, which means only a relatively small amount of material is required to fill a large volume. This reduces material waste and makes PX19-GE3259-03 a cost-effective choice.

Additionally, PX19-GE3259-03 is also available as a three-component system. This allows users to adjust the foam density to suit their own specific application requirements.

Other key statistics:

●  PX19-GE3259-03 offers good thermal performance post-cure and has an operating temperature of up to 150°c.

●  With a low viscosity of just 3000 (when mixed), this new material is very easy to process and work with.

●  The system’s slow foaming reaction generates low pressure during expansion and has a cure time of 24 hours at room temperature.

●  Robnor ResinLab PX19-GE3259-03 is RoHS compliant and can be purchased in bulk, twin-packs or 2:1 ratio cartridges.

References: https://www.robnor-resinlab.com/news/new-product-launch-px19-ge3259-03-epoxy-foam/